IMPORTANT! KEEP FOR FUTURE REFERENCE.¡IMPORTANTE! CONSÉRVELO PARA REFERENCIA FUTURA.IMPORTANT ! À CONSERVER POUR CONSU
Turn the seat carrier upside down. Pull back the binding (edge trim) of the fabric seat to reveal
Locate the seesaw toy (teeter-totter). It features a turtle and
Locate the toy bar with a bead chaser. Position the upper end of the toy bar directly above the snack tray. Then align the slot at the bottom of
Use the plastic loop under each toy bar to attach toys as desired.Use los lazos de plástico que se encuentran debajo de cada barra de juguetes p
Bounce, Bounce, Baby!™ Módulo del piano requiere (2) baterías tamaño AA/LR6 (1.5 V) (no incluidas). Use baterías alcalinas para un mejor funcion
Replace the battery cover on the piano module and tighten the screw. Do not overtighten.Vuelva a colocar la tapa de las baterías en la módulo de
Smaller babies should be placed in the activity center for only short periods of time—15 minutes maximum.The time period may be increased as
Pour changer la hauteur de la plate-forme...MISE EN GARDE : n’ajustez pas la hauteur lorsque l’enfant y est assis.Retirez l’enfant du sièg
Piano Module – To replace the piano module...Locate and remove the (2) screws underneath the play surface that fasten the piano to the play surf
Use the activity center ONLY if the child meets ALL of the following conditions:...is a
Kids II, Inc. • Alpharetta, GA 30022 USAwww.kidsii.comwww.kidsii.com/customerserviceUS/Canada 1-800-230-8190Australia (02) 9894 1855Mexico (
Tools needed – You will only need a #2 Phillips screwdriver. Tighten each screw by hand, stopping when the head is fl ush with the surface.CAUTION
Locate the play surface. It is shipped with the seat carrier placed inside.Localice la superfi cie de juego. Viene con el soporte del asiento colo
Use (2) M4 screws with washers to secure each leg to the play surface. The screws mount inside the base of each leg as shown below. Be sure to se
Locate the triangular platform and place it upside down on a smoo
Place the bungee cover over the bungee loop and pivot pin. The alignment pins on the platform must enter the two mounting posts on the bottom of
Locate the (3) height adjustment pins. Insert a height adjustment pin through the middle slot in the side of one of the legs. Be sure that the ho
Locate the fabric seat and remove it from the plastic bag. Turn the fabric so that the printed surface is on the inside and the outside is unprin
Comments to this Manuals